GSC S3 Billet Camshafts (282/282), 2008-2018 STi
Processing...

GSC S3 Billet Camshafts (282/282), 2008-2018 STi

Code: GSC-7026S3
Share: 

$1,058.68



Available For Order!
Qty

Product Description

  • This Product Can NOT Be Shipped To California!
  • Want This Product Installed? The OAKOS Service Center Is Ready To Help! Please give us a call 586-803-1750
  • Free Shipping! (Not including Alaska or Hawaii)

    • FITMENTS:
      Subaru
    • 2008-2014 STi
    • 2015-2018 STi

    • Brand: GSC Power-Division
    • Manufacturer's Part Number: 7026S3
    • Disclaimer: This product is intended for OFF ROAD use only and may not be legal for street use.
    • Off Road Use Only?: This product is intended for OFF ROAD use only and may not be legal for street use.
    • Condition: New Product



    Manufacturer's Description:
    GSC Power-Division billet S3 camshafts for the 08+ Subaru STi EJ257 with Dual AVCS. These camshafts are built to suit high horsepower cars with a power range of 750-1000 WHP and a rev range of 4500-9500 RPMs. Specific engine modifications are required to utilize the true potential of these camshafts including a built bottom-end (sleeved or closed deck reccomended), built/ported heads (casting must be clearanced for higher lift), and upgraded valve springs. A standalone ECU or tune with speed density is highly reccomended in order for proper idle characteristics.

    GSC Power-Division billet S3 camshafts for the 08+ Subaru STi EJ257 with Dual AVCS. These camshafts are built to suit high horsepower cars with a power range of 750-1000 WHP and a rev range of 4500-9500 RPMs. Specific engine modifications are required to utilize the true potential of these camshafts including a built bottom-end (sleeved or closed deck reccomended), built/ported heads (casting must be clearanced for higher lift), and upgraded valve springs. A standalone ECU or tune with speed density is highly reccomended in order for proper idle characteristics.

    • Check Pictures for cam placement. Long nose = Left Side, short nose = Right Side
    • Due to the lobe size head castings will need to be machined down for clearance - Please check during install
    • Proper break in and running high zinc oil is a must on flat tappet engines
    • Must be installed by an experienced technician
    • Check AVCS advance during install - must be done by experienced engine builder

    Inventory Updated Daily

    Customer Ratings & Reviews

    Be the first to rate this item!

    Write Review